The following options are available in the AccXES Configuration (Custom Properties) dialog box:

Override Device Settings

Overrides the label, option, stamp, and advanced settings on the printer. When this option is selected, the Edit Custom Properties button is enabled, so that you can change the label, option, stamp, and advanced settings.

Edit Custom Properties

Opens the Xerox Wide Format HDI Driver AccXES Configuration (Custom Properties) dialog box, which contains the following tabs:

• Labels
• Options
• Stamps
• Advanced

You use the settings on these tabs to control the output of the Xerox Wide Format Print System.

Gamma Correction

Specifies the gamma correction value. Valid values are integers from 1 through 5.

Gamma correction adjusts the brightness of an image. You can specify an amount to increase the intensity levels of raster data and, to a lesser extent, vector data. The gamma correction value is set to 1 by default, which applies no correction. As you increase this value, the brightness increases.

Firmware Version

Specifies the version of controller firmware in your Xerox Wide Format Print System.

The tabs in the Custom Properties dialog box vary depending on the firmware version you select. If you are not sure of the version of firmware in your Xerox Wide Format Print System, see your system administrator for help.

Use Metric Units

Specifies that the positional units in the Raster Stamp Placement X Position and Y Position fields and the Nesting Margin field are in millimeters instead of inches. When this check box is clear, the default positioning unit is inches.

Click Edit Custom Properties to configure the following options:

• Labels tab
• Options tab
• Raster Stamp tab
• Edit Stamp Names dialog box
• Advanced tab